Maintenance: Control Panel
The control panel controls all the product functions. The panel is equipped with an internal safety circuit against motor and pump short-circuits. Should your unit stop working, always check the fan motor and pumps first. The control panel may turn off, protecting itself against some other electrical defects. If the control panel is completely dead, […]
Maintenance: Float Sensor
The sensor buoy is attached to the water tank and monitors the water level. If the tank is full and the low water warning light remains on, check that the sensor is inserted correctly in the reservoir with the green dot facing up. If the sensor is inserted correctly and the light remains on it […]
Maintenance: Return Pump
The return pump is located in the tray and returns excess water to the reservoir. We recommend replacing the injection pump every 12 months. More information can be found in the maintenance section of the owner’s manual.
Maintenance: Injection Pump
The injection pump is located on the outside of the water reservoir and sends water to the Fresair unit. We recommend replacing the injection pump every 12 months. More information can be found in the maintenance section of the owner’s manual.
Maintenance: Tray Pre-Filter
The Tray Pre-Filter is located in the tray and is responsible for a second filtering process, avoiding the entry of dirt into the pump, protecting the pump from clogging and breaking down. We recommend inspecting and gently washing the filter every 6 months. Dirt can gradually accumulate which over time lowers the equipment’s performance and […]
Maintenance: Evaporative Straw Filter
The evaporative straw or pine filter is located in the tray, external air is pulled through the moistened straw causing evaporation over a large surface area resulting in the cooling of the passing air which is delivered to the internal vents. It also filters out dust, insects, and acts as a humidifier in very low […]
Maintenance: Fan
The fan is located in the center of the tray, the fan draws in external air and blows internal air through the 4 directional vents. More information can be found in the maintenance section of the owner’s manual.
Troubleshooting: Maintenance Check
We suggest performing preventative maintenance and replacing wearable parts every year (injection pump, return pump and pine filter bag), coinciding with your yearly vehicle maintenance. See full details within the owner’s manual.
Troubleshooting: Pumps
We recommend the below steps to troubleshoot each pump. Inspect return pump – Please reflect back to owner’s manual for proper maintenance. The return pump is programmed to turn on just after the injection pump to ensure there is never any excess water sitting inside the top of the unit.
General: Can you tell me about the preventative maintenance, frequency & cost?
There are two pumps for this system (injection – pumps water from the reservoir up to the roof, and return – pumps any excess water extracted from the pine filter back into the reservoir). The pine filter can be power washed but it is recommended that both pumps and pine filter be replaced once a […]