Maintenance: Control Panel
The control panel controls all the product functions. The panel is equipped with an internal safety circuit against motor and pump short-circuits. Should your unit stop working, always check the fan motor and pumps first. The control panel may turn off, protecting itself against some other electrical defects. If the control panel is completely dead, […]
Maintenance: Return Pump
The return pump is located in the tray and returns excess water to the reservoir. We recommend replacing the injection pump every 12 months. More information can be found in the maintenance section of the owner’s manual.
Maintenance: Injection Pump
The injection pump is located on the outside of the water reservoir and sends water to the Fresair unit. We recommend replacing the injection pump every 12 months. More information can be found in the maintenance section of the owner’s manual.
Troubleshooting: Pumps
We recommend the below steps to troubleshoot each pump. Inspect return pump – Please reflect back to owner’s manual for proper maintenance. The return pump is programmed to turn on just after the injection pump to ensure there is never any excess water sitting inside the top of the unit.
Reservoirs: What functions occur after the water is pumped from the reservoir to the top of the unit?
The excess water that travels through the pine filter goes through water channels and passes through (2) additional sub filters ending up inside the small reservoir built into the front of your Fresair. The return pump is located inside the small reservoir which takes all excess water and pumps it back into the main reservoir […]
Reservoirs: How do you fill the S7i internal tank once it has been installed?
There are a few options here. You could connect the S7i ‘in’ hose to the vans pressurized water supply through a valve you could open, just like you connect to a sink faucet. The ‘out’ hose could just vent outside or back to the main tank. The S7i works well for teardrops or step-vans where […]