The Tray Pre-Filter is located in the tray and is responsible for a second filtering process, avoiding the entry of dirt into the pump, protecting the pump from clogging and breaking down. We recommend inspecting and gently washing the filter every 6 months. Dirt can gradually accumulate which over time lowers the equipment’s performance and […]
An internal filter located in the tray which is responsible for filtering the excess water descending from the straw filter. The water is then recycled and returned to the water reservoir. We recommend inspecting and gently washing the filter every 6 months. Excess amounts of dirt could prevent water from cycling through, possibly cause water […]
The evaporative straw or pine filter is located in the tray, external air is pulled through the moistened straw causing evaporation over a large surface area resulting in the cooling of the passing air which is delivered to the internal vents. It also filters out dust, insects, and acts as a humidifier in very low […]
The fan is located in the center of the tray, the fan draws in external air and blows internal air through the 4 directional vents. More information can be found in the maintenance section of the owner’s manual.
The fan/motor may have shifted (likely during transit). To remedy this, please remove the top cover, then remove the cover over the fan and inspect to see if the fan blades can turn freely. Once identified, replace both covers and test the unit.
Complete the steps below to successfully winterize your system. First you’ll need to drain the water from your system, simply run the unit until the low water indicator comes on and both pumps automatically shut off. This is recommended when your Fresair will not be in use for an extended period of time.
We suggest performing preventative maintenance and replacing wearable parts every year (injection pump, return pump and pine filter bag), coinciding with your yearly vehicle maintenance. See full details within the owner’s manual.
When installing the system be careful not to pinch or crimp the return hose. If this hose is pinched or crimped water will not flow correctly back to the reservoir, resulting in water leaking from the top of the unit.
The system must be level and slightly facing downward in the front. If you overtighten the mounting bolts causing the base of the unit to curve downward – water will leak from the top of the unit. It is very important to use the included foam to create a seal around the outside of the […]
We recommend the below steps to troubleshoot each pump. Inspect return pump – Please reflect back to owner’s manual for proper maintenance. The return pump is programmed to turn on just after the injection pump to ensure there is never any excess water sitting inside the top of the unit.
